Skip to main content

Setup packet captures for Trisul

This section explains the various methods to acquire raw network packets from your infrastructure and into a Trisul Probe.

Sections in this document

  • Port Mirror– recommended for most enterprises < 500 Mbps
  • Network Taps– recommended for links > 500Mbps
  • Bridges– for small offices and appliances only

Virtual Machine configuration​

If you are installing Trisul on a Virtual Machine, you may need to put the Virtual Switch in promiscuous mode to capture the traffic on the Physical port span. See this link for instructions forVMWare

Configuring port mirror / SPAN Port​

The following diagram shows how you can configure aSPANport and feed packets into Trisul. See your switch vendor’s documentation on configurating a PortSPANsession. [CiscoSPANdocumentation]

SPANexampleportsge/0/0/1andge/0/0/12traffic mirrored toge/0/0/6which is then connected to Trisul-Probe

Using Network Taps​

SPANports quickly become unweildy as network speeds increase. Network taps are available as Copper and Optical modules that are the preferred choice for high speed networks.

Network Tap used with 10G optical fiber. Each direction needs a tap and sent to two ports on Trisul-Probe

Using Trisul as a bridge​

For small office networks you can even use 2 Ports of the box running Trisul and create a bridge. This places Trisul as an inline device.

Bridge : Use the Trisul-Probe inline as a bridge. Useful for small deployments

Bridging Ethernet Connections​

A bridge allows you to connect two or more network segments together allowing devices to join the network when it’s not possible to connect them directly to a router or switch

How to bridge​

UBUNTU

Install the bridge-utils package.

Copysudo apt-get install bridge-utils

Automatically Create the Bridge at Start-up
Sample/etc/network/interfaces file

Install the bridge-utils package.
sudo apt-get install bridge-utils
Automatically Create the Bridge at Start-up
Sample /etc/network/interfaces file
 BASH#eth0
auto eth0
iface eth0 inet manual
up ifconfig eth0 up
#eth1
auto eth1
iface eth1 inet manual
up ifconfig eth1 up
#bridge br0
auto br0
iface br0 inet static
address 192.168.2.79
gateway 192.168.2.1
netmask 255.255.255.0
bridge_ports eth0 eth1

Restart networking

sudo /etc/init.d/networking restart

CENTOS

Install the bridge-utils package.

Copyyum install bridge-utils

To create a network bridge, create a file in the/etc/sysconfig/network-scripts/directory calledifcfg-br0
sample/etc/sysconfig/network-scripts/ifcfg-br0

DEVICE=br0
TYPE=Bridge
IPADDR=192.168.2.78
GATEWAY=192.168.2.1
NETMASK=255.255.255.0
ONBOOT=yes
BOOTPROTO=none
NM_CONTROLLED=no
DELAY=0

To complete the bridge another interface is created, or an existing interface is modified, and pointed to the bridge interface sample/etc/sysconfig/network-scripts/ifcfg-eth0

DEVICE=eth0
TYPE=Ethernet
HWADDR=AA:BB:CC:DD:EE:FF
BOOTPROTO=none
ONBOOT=yes
NM_CONTROLLED=no
BRIDGE=br0

sample/etc/sysconfig/network-scripts/ifcfg-eth1

DEVICE=eth1
TYPE=Ethernet
HWADDR=AA:BB:CC:DD:EE:FG
BOOTPROTO=none
ONBOOT=yes
NM_CONTROLLED=no
BRIDGE=br0

Restart networking

/etc/init.d/netwok restart